Building a DIY 5.1 Audio Video Receiver – Part 6

In the last post I mentioned that I was looking for a crossover board. The one that I purchased is putting out a huge DC bias and I was not comfortable using it on my sub woofer. Wondering if it is a problem with the particular unit that I got, I ordered a replacement. Unfortunately, even the replacement has the same signature output. So I decided to do something about it myself. AC coupling capacitor For those of you who have done electrical engineering might recognize that adding a capacitor in series with the load will block DC offset. This … Continue reading “Building a DIY 5.1 Audio Video Receiver – Part 6”

Building a DIY 5.1 Audio Video Receiver – Part 5

So far I have finished bringing up 4 of my 5.1 speakers in my DIY 5.1 AVR project. If you missed, check out part 1, part 2, part 3 and part 4 of the series. Next I wanted to bring up my sub-woofer. Since I have an active sub-woofer, I did not need any amplifiers to drive it. I just need to connect the output signal from my audio source directly to the sub-woofer input. But there is a catch. If you connect the audio source directly to the sub-woofer, the sub would be wasting a lot of energy which … Continue reading “Building a DIY 5.1 Audio Video Receiver – Part 5”