Posts tagged with “tda7498”

Oct 19, 2020
Building a DIY 5.1 Audio Video Receiver – Part 4
As I mentioned in my last post, after measuring the frequency response and testing the TDA 7498, I decided to buy one more. The board I bought earlier did not have the right LC filter for a 6 ohms speaker. It was designed for 8 ohms speaker. So I decided to use that board for my rear surround speakers which were also 6 ohms. However, it is fine to have a slightly poor quality amp for the rarely used rear speakers.
...continue reading
Oct 13, 2020
Building a DIY 5.1 Audio Video Receiver – Part 3
The TDA7498 class D amplifier board that I purchased to power my front speakers was working great. The audio quality is at par with what my Pioneer 5.1 AVR delivered using class AB amplifier. I could not tell the difference in audio quality. None the less, I wanted to make sure the quality is really as good as my ears led me to believe. Enter a function generator and oscilloscope to make sure the frequency response is satisfactory over the range of audible frequencies (20 Hz to 20 kHz).
...continue reading
Oct 6, 2020
Building a DIY 5.1 Audio Video Receiver – Part 2
If you did not read part 1 of building a DIY 5.1 AVR, I suggest you start from there. Here is some important points from my previous post --
...continue reading