Building a DIY 5.1 Audio Video Receiver – Part 4

As I mentioned in my last post, after measuring the frequency response and testing the TDA 7498, I decided to buy one more. The board I bought earlier did not have the right LC filter for a 6 ohms speaker. It was designed for 8 ohms speaker. So I decided to use that board for my rear surround speakers which were also 6 ohms. However, it is fine to have a slightly poor quality amp for the rarely used rear speakers. Then I set out searching for another TDA 7498 speaker amplifier board with a 680 nF capacitor RC filter. … Continue reading “Building a DIY 5.1 Audio Video Receiver – Part 4”

Building a DIY 5.1 Audio Video Receiver – Part 3

The TDA7498 class D amplifier board that I purchased to power my front speakers was working great. The audio quality is at par with what my Pioneer 5.1 AVR delivered using class AB amplifier. I could not tell the difference in audio quality. None the less, I wanted to make sure the quality is really as good as my ears led me to believe. Enter a function generator and oscilloscope to make sure the frequency response is satisfactory over the range of audible frequencies (20 Hz to 20 kHz). If you don’t happen to know, a class D amplifier uses … Continue reading “Building a DIY 5.1 Audio Video Receiver – Part 3”