Building a DIY 5.1 Audio Video Receiver – Part 3

The TDA7498 class D amplifier board that I purchased to power my front speakers was working great. The audio quality is at par with what my Pioneer 5.1 AVR delivered using class AB amplifier. I could not tell the difference in audio quality. None the less, I wanted to make sure the quality is really as good as my ears led me to believe. Enter a function generator and oscilloscope to make sure the frequency response is satisfactory over the range of audible frequencies (20 Hz to 20 kHz). If you don’t happen to know, a class D amplifier uses … Continue reading “Building a DIY 5.1 Audio Video Receiver – Part 3”

Building a DIY 5.1 Audio Video Receiver – Part 1

Alright, you already know the story of my electronics going puff during a power surge. One of the electronics that got burnt was my unnecessarily expensive Pioneer 5.1.2 AVR. The reason I put emphasis on unnecessary is because I rarely used all the features of the device. Don’t even know why I spent all the money :). After it stopped working, I opened and checked everything that I could figure out. But I didn’t notice any obvious problems. The AVR just boots up, turns on the amplifier relay and turns off. Since it failed during COVID lock down, I couldn’t … Continue reading “Building a DIY 5.1 Audio Video Receiver – Part 1”